Cisco Cisco Tunnel Terminating Gateway (TTG)
check-point accounting
This command configures micro checkpoint syncup timer for ICSR and Session Recovery for Rf-Gy
synchronization.
synchronization.
Product
GGSN
P-GW
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration
active-charging service service_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-acs)#
Syntax Description
check-point accounting sync-timer { icsr | sr } timer_value [ sr | icsr ] timer_value
no check-point accounting sync-timer { icsr | sr }
no check-point accounting sync-timer { icsr | sr }
no
If the micro checkpoint syncup timer is already configured, then the no variant will delete the configuration.
sr timer_value
Configures micro check-pointing timer for Session Recovery (SR). By default, the session recovery
check-pointing will be done on 8 seconds.
check-pointing will be done on 8 seconds.
timer_value: Time configured will be in multiples of 2 seconds. Note that the timer value less than 4 seconds
and greater than 60 seconds will not be accepted.
and greater than 60 seconds will not be accepted.
icsr timer_value
Configures micro check-pointing timer for ICSR. By default, the ICSR check-pointing will be done on 18
seconds.
seconds.
timer_value: Time configured will be in multiples of 2 seconds. Note that the timer value less than 4 seconds
and greater than 60 seconds will not be accepted.
and greater than 60 seconds will not be accepted.
Usage Guidelines
Use this command to configure micro checkpoint syncup timer for ICSR and Session Recovery. Micro
Checkpoint Sync-up timer is an internal timer utilized by Rf and Gy modules to check point corresponding
billing information.
Checkpoint Sync-up timer is an internal timer utilized by Rf and Gy modules to check point corresponding
billing information.
Command Line Interface Reference, Modes A - B, StarOS Release 19
374
ACS Configuration Mode Commands
check-point accounting