Cisco Cisco Packet Data Gateway (PDG)
threshold dereg-reply-error
Sets an alarm or alert based on the number of de-registration reply errors per HA service.
Product
HA
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > HA Service Configuration
configure > context context_name > ha-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ha-service)#
Syntax Description
threshold dereg-reply-error high_thresh [ clear low_thresh ]
no threshold dereg-reply-error
no threshold dereg-reply-error
no
Deletes the alert or alarm.
high_thresh
Default: 0
Specifies the high threshold number of de-registration reply errors that must be met or exceeded within the
polling interval to generate an alert or alarm. It can be configured to an integer from 0 through 100000.
polling interval to generate an alert or alarm. It can be configured to an integer from 0 through 100000.
clear low_thresh
Default: 0
The low threshold number of de-registration reply errors that must be met or exceeded within the polling
interval to clear an alert or alarm. It can be configured to an integer from 0 through 100000.
interval to clear an alert or alarm. It can be configured to an integer from 0 through 100000.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Usage Guidelines
Use this command to set an alert or an alarm when the number of de-registration reply errors is equal to or
greater than a specified number of calls per second.
greater than a specified number of calls per second.
Command Line Interface Reference, Modes G - H, StarOS Release 19
1289
HA Service Configuration Mode Commands
threshold dereg-reply-error