Cisco Cisco Packet Data Gateway (PDG)
where the IP address must be expressed in dotted decimal notation for IPv4 or colon notation for IPv6, and
the mask bits are a numeric value, which is the number of bits in the subnet mask.
the mask bits are a numeric value, which is the number of bits in the subnet mask.
range start_ip_address end_ip_address: Configure UE IP range for specific access-type.
• start_ip_address specifies the beginning of the range of addresses.
• end_ip_address specifies the end of the range of addresses.
• ip_address must be expressed in dotted decimal notation for IPv4 or colon notation for IPv6.
Usage Guidelines
Use this command to associated the access types for a specified CSCF access profile or UE IP address/range
name.
name.
Use the sip-header command to enable SIP P-Access-Network-Info (PANI) header insertion. CSCF
Proxy-CSCF Configuration Mode commands are defined in the CSCF Proxy-CSCF Configuration Mode
Commands chapter in this guide.
Proxy-CSCF Configuration Mode commands are defined in the CSCF Proxy-CSCF Configuration Mode
Commands chapter in this guide.
Important
Examples
The following command identifies the access type adsl and assigns it to access profile ap1:
access-type adsl access-profile name ap1
access-type adsl access-profile name ap1
Command Line Interface Reference, Modes C - D, StarOS Release 19
1521
CSCF Service Configuration Mode Commands
access-type