Cisco Cisco Tunnel Terminating Gateway (TTG)
show subscribers samog-only
Displays SaMOG specific context information for the session.
Product
SaMOG
Privilege
Inspector
Syntax Description
show subscribers samog-only [ [ all ] [ callid call_id ] [ card-num card_num ]
[ connected-time
[ < | > | greater-than | less-than ] connected_time ] [ full ] [ idle-time [ < | > | greater-than | less-than
] idle_time ] [ ip-address [ < | > | greater-than | less-than ] ipv4_adress ] [ ipv6-prefix ipv6_prefix
] idle_time ] [ ip-address [ < | > | greater-than | less-than ] ipv4_adress ] [ ipv6-prefix ipv6_prefix
] [ network-type { gre | ipip | ipsec | ipv4 | ipv4-pmipv6 | ipv4v6 | ipv4v6-pmipv6 | ipv6 | ipv6-pmipv6
| l2tp | mobile-ip | proxy-mobile-ip } ]
[ session-time-left [ < | > | greater-than | less-than ]
session_time_left ] [ smgr-instancesmgr_instance ] [ summary ] [ username user_name ] [ | { grep
grep_options | more } ] ]
idle-time [ < | > | greater-than | less-than ] idle_time
Displays how long the subscriber has been idle.
> and greater-than Specifies greater than. This must be followed by idle_time, an integer ranging from 0and
4294967295.
4294967295.
< and less-than Specifies less than. This must be followed by idle_time, an integer ranging from 0and
4294967295.
4294967295.
ipv6-prefix ipv6_prefix
Displays the subscribers associated with the specified IPv6 address prefix. Must be followed by an IPv6
address prefix in the format xx:xx:xx::/len
address prefix in the format xx:xx:xx::/len
| { grep grep_options | more }
Pipes (sends) the output of this command to a specified command. You must specify a command to which
the output of this command will be sent.
the output of this command will be sent.
For details on using the grep and more commands, refer to the Regulating a Command's Output section of
the Command Line Interface Overview chapter.
the Command Line Interface Overview chapter.
Command Line Interface Reference, Modes E - F, StarOS Release 19
1566
Exec Mode show Commands (Q-S)
show subscribers samog-only