Cisco Cisco ASR 5000

Page of 9109
  APN Configuration Mode Commands 
dhcpv6 service-name  ▀   
 
Command Line Interface Reference, StarOS Release 18  ▄  
 
   
1341 
dhcpv6 service-name 
Specifies which DHCPV6 service to use, if the alloc-type is configured as dhcpv6-client or dhcpv6-relay. 
Product
 
GGSN 
P-GW 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > Context Configuration > APN Configuration 
configure > context context_name > apn apn_name
 
Entering the above command sequence results in the following prompt: 
[context_name]host_name(config-apn)# 
Syntax
 
no ] dhcpv6 service-name service_name 
no
 
Removes a previously configured DHCPv6 service name. 
service_name
 
Configures the name of the DHCPv6 service instance that is to be used by the current APN for the dynamic 
assignment of IPv6 addresses to PDP contexts. The name can be an alphanumeric string of 1 through 63 
characters that is case sensitive. 
Usage 
Use this command to specify a pre-configured DHCPv6 service instance that is to be used by the APN for 
IPv6 address assignment when the Dynamic Host Control Protocol is used. 
The name of the context in which the desired DHCP service is configured must be specified by the 
dhcpv6 
context-name
 command. 
Important:
  Only one DHCPv6 service can be configured for an APN 
Example
 
The following command instructs the APN to use a DHCPv6 service called 
dhcpv6_svc
dhcp service-name dhcpv6_svc