Cisco Cisco ASR 5000
Call Control Profile Configuration Mode
local-cause-code-mapping gw-unreachable ▀
Command Line Interface Reference, StarOS Release 18 ▄
2013
Usage
Use this command to configure the cause code returned to a UE when a gateway (S-GW or P-GW) does not
respond during an EMM procedure.
Defaults:
Prior to StarOS 15.0 MR5, the MME sends the UE the #19 - ESM Failure cause code when encountering
this condition.
In StarOS 15.0 MR5 and higher releases, the MME sends the UE the #19 - ESM Failure cause code for
Attach procedures, and #40 - NO-EPS-BEARER-CONTEXT-ACTIVATED for TAU procedures.
respond during an EMM procedure.
Defaults:
Prior to StarOS 15.0 MR5, the MME sends the UE the #19 - ESM Failure cause code when encountering
this condition.
In StarOS 15.0 MR5 and higher releases, the MME sends the UE the #19 - ESM Failure cause code for
Attach procedures, and #40 - NO-EPS-BEARER-CONTEXT-ACTIVATED for TAU procedures.
Related Commands:
If a cause code mapping is specified in both the call-control-profile associated with a call, and also the mme-
service, the cause configured for the call-control-profile will be signalled to the UE. See also the
service, the cause configured for the call-control-profile will be signalled to the UE. See also the
local-
cause-code-mapping
command in the mme-service configuration mode. This command is described in the
MME Service Configuration Mode Commands chapter.
Example
The following command maps the “network-failure” cause code to the gateway unreachable condition:
local-cause-code-mapping gw-unreachable emm-cause-code network-failure