Cisco Cisco ASR 5000
Call Control Profile Configuration Mode
▀ network-initiated-pdp-activation
▄ Command Line Interface Reference, StarOS Release 18
2048
213 - Relocation failure
214 - Unknown mandatory extension header
215 - Semantic error in the TFT operation
216 - Syntactic error in the TFT operation
217 - Semantic errors in packet filter(s)
218 - Syntactic errors in packet filter(s)
219 - Missing or unknown APN
220 - Unknown PDP address or PDP type
221 - PDP context without TFT already activated
222 - APN access denied – no subscription
223 - APN Restriction type incompatibility with currently active PDP Contexts
224 - MS MBMS Capabilities Insufficient
225 - Invalid Correlation-ID
226 - MBMS Bearer Context Superseded
Usage
Use this command to allow or restrict network-requested PDP context activation (NRPCA) based on access-
type and location areas. NRPCA is used when there is downlink data at the GGSN for a subscriber, but there
is no valid context for the already-established PDP address so the GGSN initiates an NRPCA procedure
towards the SGSN.
This command can also be used to define the failure cause code that will be included in activation reject
messages.
These commands can be repeated to define a unique set of NRPCA parameters for each access-type and each
location area list.
The
type and location areas. NRPCA is used when there is downlink data at the GGSN for a subscriber, but there
is no valid context for the already-established PDP address so the GGSN initiates an NRPCA procedure
towards the SGSN.
This command can also be used to define the failure cause code that will be included in activation reject
messages.
These commands can be repeated to define a unique set of NRPCA parameters for each access-type and each
location area list.
The
T3385-timeout
and the
max-actv-retransmission
timers configure the retransmission timer and
the number of retries for PDP context activation requests. Both of these timers are set in the SGSN service
configuration mode.
The configuration for NRPCA can be viewed via the
configuration mode.
The configuration for NRPCA can be viewed via the
show call-control-profile full name
profile_name
. Statistics associated with NRPCA can be seen via the
show gmm-sm statistics
output
and via the
show sgtpc statistics verbose
output.
Example
The following command changes the failure code for Reject messages from 200 (service not supported) to
205 (roaming restriction) for primary NRPCA for all GRPS access and all LACs:
205 (roaming restriction) for primary NRPCA for all GRPS access and all LACs:
network-initiated-pdp-activation primary access-type gprs all failure-
code 205
code 205
The following command enables network-initiated primary PDP context activation for UMTS calls from the
LACs in location-area-list 1:
LACs in location-area-list 1:
network-initiated-pdp-activation allow primary access-type umts location-
area-list instance 1
area-list instance 1
The following command restricts network-initiated primary PDP context activation for UMTS calls from the
LACs in location-area-list 2:
LACs in location-area-list 2: