Cisco Cisco ASR 5000

Page of 9109
Call Control Profile Configuration Mode   
▀  prefer subscription-interface 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
2064 
   
prefer subscription-interface 
Selects the specified subscription interface (Gr or S6d) if both interface types are associated with a call-control-profile. 
Use of this command requires an S6d license. The SGSN also allows selection of S6d interface only if the UE is EPC 
capable. The keyword 
epc-ue
 supports the selection of HSS interface only for EPC capable subscribers. 
Product
 
SGSN 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > Call Control Profile Configuration 
configure > call-control-profile profile_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-call-control-profile-profile_name)# 
Syntax
 
prefer subscription-interface { hlr | hss [ epc-ue ] } 
remove prefer subscription-interface 
remove
 
Removes the preferred subscription-interface for the call control profile. 
hlr
 
Selects the HLR Gr interface. 
hss
 
Selects the HSS S6d interface. 
epc-ue
 
Configure this keyword to select the HSS interface for EPC capable subscribers. For other subscribers the MAP 
interface will be selected. This keyword will be applicable only when both MAP and HSS interfaces are configured in 
the Call-control profile. If this keyword is not configured then SGSN follows existing logic for interface selection. The 
interface selection based on UE capability is done only at the time of Attach / new SGSN RAU / SRNS. Once the 
interface is selected, the subscriber remains in same interface till the UE moves out of the SGSN. 
Usage 
Use of this command requires an S6d license. 
The SGSN provides a mechanism to associate a MAP service with call control profile. It is possible that both 
MAP service and HSS peer service are associated with the call control profile. If the interface preference 
selected is “hlr”, the MAP protocol is used to exchange messages with the HLR. If the interface preference 
selected is “hss”, the Diameter-protocol is used to exchange messages with the HSS. 
Example
 
The following command specifies that “hss” for S6d is selected as the subscription-interface: