Cisco Cisco ASR 5000

Page of 9109
Context Configuration Mode Commands E-H   
▀  egtp-service 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
2434 
   
Caution:
  Large numbers of services greatly increase the complexity of management and may impact overall 
system performance (for example, resulting from such things as system handoffs). Therefore, it is recommended that a 
large number of services only be configured if your application absolutely requires it. Please contact your local service 
representative for more information. 
Entering this command results in the following prompt: 
[context_name]hostname(config-egtp-service)# 
eGTP Service Configuration Mode commands are defined in the eGTP Service Configuration Mode 
Commands
 chapter. 
Use this command when configuring the following GTP SAE components: MME, P-GW, and S-GW. Also 
use this command when configuring an S4-SGSN. Once the eGTP service has been created on the S4-SGSN, 
the eGTP service must be configured using the 
gtpc
validation-mode
 and 
interface-type
 commands 
in eGTP Service Configuration Mode. Once the service is created and configured, it then must be associated 
with the 2G and/or 3G services configured on the S4-SGSN using the
associate
 command in Call Control 
Profile Configuration Mode
Example
 
The following command enters the existing eGTP Service Configuration Mode (or creates it if it does not 
already exist) for the service named 
egtp-service1
egtp-service egtp-service1 
The following command will remove 
egtp-service1
 from the system: 
no egtp-service egtp-service1