Cisco Cisco ASR 5000

Page of 9109
  Accounting Policy Configuration Mode Commands 
rf  ▀   
 
Command Line Interface Reference, StarOS Release 18  ▄  
 
   
245 
rf 
This command controls the reporting of subscriber traffic data for Rating Groups (RGs) based on the generation of 
Interim Record (IR). 
Product
 
GGSN 
HSGW 
P-GW 
S-GW 
SAEGW 
Privilege
 
Administrator 
Mode
 
Exec > Global Configuration > Context Configuration > Accounting Policy Configuration 
configure > context context_name > policy accounting policy_name
 
Entering the above command sequence results in the following prompt: 
[context_name]host_name(config-accounting-policy)# 
Syntax
 
rf report-all-active-rgs 
{ default | no } rf report-all-active-rgs 
default | no
 
The default behavior is to disable traffic data reporting in Service Data Container (SDC) for all active Rating 
Groups (RGs) whenever an interim is sent. 
report-all-active-rgs
 
This keyword enables to report the traffic data in the SDC for all the active RGs whenever an IR is sent. By 
default, this feature is enabled. 
Usage 
There are several change conditions where a partial Service Data Container (SDC) is not cut for a particular 
RG but ACR-Interim is generated due to maximum change conditions. There are many triggers like time 
limit, volume limit, etc., that will lead to maximum change condition. Because of this some RGs SDC may 
not be generated for a longer period of time. 
In releases prior to 18.0, when a Maximum Change Condition event was triggered, only those RGs that have 
hit one of the Change Conditions that require a caching of data as opposed to cutting an IR, used to have their 
data in the generated IR. In 18.0 and later releases, when the Maximum Change Condition happens, the 
current Rf implementation is changed to make sure all RGs that have not been cached have a snapshot of 
their usage taken.