Cisco Cisco ASR 5000
Context Configuration Mode Commands E-H
gtpp data-request sequence-numbers ▀
Command Line Interface Reference, StarOS Release 18 ▄
2469
gtpp data-request sequence-numbers
Configures the range of sequence numbers to be used in the GTPP data record transfer record (DRT). Use this command
to set the start value for the sequence number.
to set the start value for the sequence number.
Product
GGSN
SGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
gtpp data-request sequence-numbers start { 0 | 1 }
default gtpp data-request sequence-numbers start
default
Default is 0 (zero).
{ 0 | 1 }
Specifies the value of the start sequence number for the GTPP Data Record Transfer Request. Default: 0
0
: Designates the start sequence number as 0.
1
: Designates the start sequence number as 1.
Usage
When the GGSN/P-GW (SAEGW)/SGSN is configured to send GTPP echo request packets, the SGSN
always uses 0 as the sequence number in those packets. Re-using 0 as a sequence number in the DRT packets
is allowed by the 3GPP standards; however, this CLI command ensures the possibility of inter-operating with
CGFs that can not properly handle the re-use of sequence number0 in the echo request packets.
always uses 0 as the sequence number in those packets. Re-using 0 as a sequence number in the DRT packets
is allowed by the 3GPP standards; however, this CLI command ensures the possibility of inter-operating with
CGFs that can not properly handle the re-use of sequence number0 in the echo request packets.
Example
The following command sets the sequence to start at
1
.
gtpp data-request sequence-numbers start 1