Cisco Cisco ASR 5000
Context Configuration Mode Commands I-M
ipv6 rri ▀
Command Line Interface Reference, StarOS Release 18 ▄
2611
ipv6 rri
Configures Reverse Route Injection (RRI) egress clear port IPv6 parameters. (VPC-VSM only)
Product
SecGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
ipv6 rri { ipv6_address | next-hop nexthop_address } interface interface_name [ vrf
vrf_name ]
vrf_name ]
no ipv6 rri { ipv6_address | next-hop nexthop_address } interface interface_name [ vrf
vrf_name ]
vrf_name ]
no
Disables the specified RRI egress route.
ipv6_address
Specified in IPv6 colon-separated-hexadecimal notation.
next-hop
nexthop_address
Next hop address specified in IPv6 colon-separated-hexadecimal notation. The next hop IP address is not
required for point-to-point and tunnel interfaces.
required for point-to-point and tunnel interfaces.
interface
interface_name
Specifies the name of an existing egress interface as an alphanumeric string of 1 through 79 characters.
vrf
vrf_name
Specifies the name of an existing VRF as an alphanumerical string of 1 through 63 characters.
Usage
Use this command to configure IPv6 RRI egress clear port IPv6 parameters.
Example
ipv6 rri 2001:4A2B::1f3F interface rri03