Cisco Cisco ASR 5000
Crypto Map IPSec Manual Configuration Mode Commands
▀ set peer
▄ Command Line Interface Reference, StarOS Release 18
3008
set peer
Configures the IP address of the peer security gateway that the system will establish the IPSec tunnel with.
Product
ePDG
FA
GGSN
HA
HeNBGW
HNBGW
HSGW
MME
P-GW
PDSN
S-GW
SAEGW
SCM
SecGW
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Crypto Map Manual Configuration
configure > context
context_name
> crypto map
map_name
ipsec-manual
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-crypto-manual-map)#
Syntax
[ no ] set peer
gw_address
no
Removes a previously configured peer address.
set peer
gw_address
Specifies the IP address of the peer security gateway with which the IPSec tunnel will be established. The IP
address can be in IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation.
address can be in IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation.