Cisco Cisco ASR 5000

Page of 9109
Diameter Endpoint Configuration Mode Commands   
▀  app-level-retransmission 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
3532 
   
app-level-retransmission 
This command enables/disables setting “T” bit and retaining the same End-to-End Identifier (E2E ID) for application-
level retransmissions. 
Product
 
eHRPD 
GGSN 
P-GW 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > Context Configuration > Diameter Endpoint Configuration 
configure > context context_name > diameter endpoint endpoint_name
 
Entering the above command sequence results in the following prompt: 
[context_name]host_name(config-ctx-diameter)# 
Syntax
 
[ default | no ] app-level-retransmission { retain-e2e | set-retransmission-bit } 
default
 
Configures this command with the default setting. 
The default behavior is not to set the retransmission bit for a retried Diameter message. 
retain-e2e
 
Sends the same End-to-End Identifier for a retried Diameter message. 
set-retransmission-bit
 
Sets the retransmission bit for retried Diameter messages. 
Usage 
Use this command to enable application-level transmission with “T” bit set.  
'T' bit setting is done only for DIABASE protocol-based rerouting and not for application-based 
retransmissions. In order to identify such retransmissions, the server expects the T bit to be set at all levels 
(both DIABASE and application) of retransmission, which can be achieved with this CLI command. 
In addition to using this CLI command for setting the T-bit in a retried message, it is also possible to retain 
the same End-to-End ID. With this feature turned on, the server can detect any duplicate/re-transmitted 
messages sent by Diameter clients or agents. Note that this feature is applicable to Gy and Rf messages as 
well. 
Similar CLI command for setting T-bit is also present under Credit Control Group configuration mode, which 
when configured will take effect for Gy messages else endpoint configuration will be used.  
Example
 
The following command specifies to set retransmission bit and retain e2e: