Cisco Cisco ASR 5000

Page of 9109
  Ethernet Interface Configuration Mode Commands 
port-switch-on-L3-fail  ▀   
 
Command Line Interface Reference, StarOS Release 18  ▄  
 
   
3755 
port-switch-on-L3-fail 
Causes the ASR 5000 line card port or the ASR 5500 MIO port to which the current interface is bound to switch over to 
the port on the redundant line card or MIO when connectivity to the specified IP address is lost. 
Product
 
All 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > Context Configuration > Ethernet Interface Configuration 
configure > context context_name > interface interface_name broadcast
 
Entering the above command sequence results in the following prompt: 
[context_name]host_name(config-if-eth)# 
Syntax
 
port-switch-on-L3-fail address { ip_address | ipv6_address } [ minimum-switchover-period 
switch_time ] [ interval int_time ] [ timeout time_out ] [ num-retry number ] 
no port-switch-on-L3-fail 
no
 
Disable port switchover on failure. 
ip_address
 
The IP address to monitor for connectivity, entered in IPv4 dotted-decimal or IPv6 colon-separated-
hexadecimal notation. 
minimum-switchover-period
 
switch_time
 
After a switchover occurs, another switchover cannot occur until the specified amount of time (in seconds) 
has elapsed. 
switch_time
 must be an integer from 1 through 3600. Default: 120 
interval
 
int_time
 
Specifies how often (in seconds) monitoring packets are sent to the IP address being monitored. 
int_time
 
must be an integer from 1 through 3600. Default: 60 
timeout
 
time_out
 
Specifies how long to wait (in seconds) without a reply before resending monitoring packets to the IP address 
being monitored. 
time_out
 must be an integer from 1 through 10. Default: 3 
num-retry
 
number
 
Specifies how many times to retry sending monitor packets to the IP address being monitored before 
performing the switchover. 
number
 must be an integer from 1 through 100. Default: 5