Cisco Cisco ASR 5000

Page of 9109
ACL Configuration Mode Commands   
▀  redirect nexthop (by TCP/UDP packets) 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
378 
   
before
 
Indicates all rules defined subsequent to this command are to be inserted before the command identified by 
the exact options listed. 
This moves the insertion point to be immediately before the rule which matches the exact options specified 
such that new rules will be added, in order, before the matching rule. 
Important:
  If the options specified do not exactly match an existing rule, the insertion point does not change. 
no
 
Removes the rule which exactly matches the options specified. 
nexthop nexthop_addr
 
The directly connected IP address to which the IP packets are forwarded. 
context context_id
 
The context identification number of the context to which packets are redirected. At the executive mode 
prompt, use the 
show context all
 command to display context names and context IDs. 
interface interface_name
 
The name of the logical interface to which the packets should be redirected. 
interface_name
 must be an 
alphanumeric string from 1 through 79 characters. 
log
 
Default: packets are not logged. 
Indicates all packets which match the redirect are to be logged. 
tcp | udp
 
Specifies the redirect is to be applied to IP based transmission control protocol or the user datagram protocol. 
 
tcp
: Redirect applies to TPC packets. 
 
udp
: Redirect applies to UDP packets. 
source_address
 
The IP address(es) from which the packet originated. 
This option is used to filter all packets from a specific IP address or a group of IP addresses. 
When specifying a group of addresses, the initial address is configured using this option. The range can then 
be configured using the 
source_wildcard
 parameter. 
source_wildcard
 
This option is used in conjunction with the 
source_address
 option to specify a group of addresses for 
which packets are to be filtered. 
The mask must be entered as a complement: 
 
Zero-bits in this parameter mean that the corresponding bits configured for the 
source_address
 
parameter must be identical. 
 
One-bits in this parameter mean that the corresponding bits configured for the 
source_address
 
parameter must be ignored.