Cisco Cisco ASR 5000

Page of 9109
  Exec Mode Commands (A-C) 
card halt  ▀   
 
Command Line Interface Reference, StarOS Release 18  ▄  
 
   
3803 
card halt 
Halts all StarOS processes on a card. A 
card reboot
 command must be issued to bring the card back into service after 
it is halted. (ASR 5x00 only) 
Product
 
All 
Privilege
 
Security Administrator, Administrator, Operator 
Mode
 
Exec 
The following prompt is displayed in the Exec mode: 
[local]host_name
Syntax
 
card halt slot_num [ -force ] [ -noconfirm ] 
slot_num
 
Indicates the slot number of the card of interest. 
-force
 
Over-rides any warnings to force the card to be halted. 
-noconfirm
 
Executes the command without any additional prompt and confirmation from the user. 
Usage 
Halt a card to stop the card for maintenance or emergency situations. 
Caution:
  Caution should be taken in using this command. Halting a card which has no redundant card available 
may cause a service interruption and loss of active sessions. 
Important:
  On the ASR 5500, do not initiate a card halt for an active FSC if there are less than two active FSCs 
in the system. The system returns an error message if there are less than four active FSCs. 
Caution:
  The 
-force
 and 
-noconfirm
 options should only be used concurrently by experienced users as this 
will cause an immediate halt regardless of warnings and no confirmation from the user. 
Important:
  This command is not supported on all platforms. 
Example
 
The following command temporarily stops the card in slot 1.