Cisco Cisco ASR 5000

Exec Mode Commands (D-S)

egtpc test echo ▀

Command Line Interface Reference, StarOS Release 18 ▄

4093

egtpc test echo

Tests the ability of a GGSN/P-GW service to exchange GTP-C echo request messages with specified peer(s).

Product

GGSN

P-GW

SAEGW

Privilege

Operator, Config-Administrator, Administrator

Mode

Exec

The following prompt is displayed in the Exec mode:

[local]host_name#

Syntax

egtpc test echo gtp-version version src-address ip_address { all | peer-address
ip_address }

gtp-version version

Specifies version number for sending Echo request message.

version

must be an integer from 0 through 2.

Important:

If peer is not a new peer for service bind to

src-address

, then echo request is sent with the last

known highest version of the peer.

src-address

ip_address

Specifies the IP address of a Gn interface configured on the system.

ip_address

must be entered using IPv4 dotted-decimal notation or IPV6 colon-separated-hexadecimal

notation.

Important:

The IP address of the system’s Gn interface must be bound to a configured GGSN/P-GW service

prior to executing this command.

all

Sends GTP-C echo requests to first 100 peers that currently have sessions with the GGSN/P-GW service.

Important:

If this keyword is selected, additional confirmation is required after the following message,

“Warning: Due to possibility of huge number of connected peers, considering system performance impacts, issue echo
request to only 100 peers”.