Cisco Cisco ASR 5000

Page of 9109
Exec Mode Commands (D-S)   
▀  gtpu test echo 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
4112 
   
gtpu test echo 
Tests the ability of a GGSN/P-GW/SAEGW/SGSN/S-GW service to exchange GTP-U echo request messages with 
specified peer(s). 
Product
 
GGSN 
P-GW 
SAEGW 
SGSN 
S-GW 
Privilege
 
Operator, Config-Administrator, Administrator 
Mode
 
Exec 
The following prompt is displayed in the Exec mode: 
[local]host_name
Syntax
 
StarOS v12.x and earlier: 
gtpu test echo src-address gn_address { all | sgsn-address ip_address } 
StarOS v14.0 and later: 
gtpu test echo gtpu-service service_name { all | peer-address ip_address } [ gtpu-version 
{ 0 | 1 } ]
 
src-address
 
gn_address
 
Specifies the IP address of a Gn interface configured on the system using IPv4 dotted-decimal notation. 
Important:
  The IP address of the system’s Gn interface must be bound to a configured GGSN service prior to 
executing this command. 
all
 
Sends GTP-U echo requests to all SGSNs that currently have sessions with the GGSN service. 
sgsn-address
 
ip_address
 
Sends GTP-U echo requests to an SGSN specified by its IP address in IPv4 dotted-decimal notation. 
gtpu-service service_name
 
Specifies an existing GTP-U service. 
service_name
 is an alphanumeric string of 1 through 63 characters.