Cisco Cisco ASR 5000

Page of 9109
  ACS Configuration Mode Commands 
fw-and-nat action  ▀   
 
Command Line Interface Reference, StarOS Release 18  ▄  
 
   
495 
fw-and-nat action 
This command allows you to create/configure/delete Firewall-and-NAT actions. 
Important:
  This command is available only in 11.0 and later releases. This command must be used to configure 
the Stateful Firewall and NAT Action. 
Product
 
PSF 
NAT 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > ACS Configuration 
active-charging service service_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-acs)# 
Syntax
 
fw-and-nat action action_name [ -noconfirm ] 
no fw-and-nat action action_name 
no
 
If previously configured, deletes the specified Firewall-and-NAT action from the active charging service. 
action_name
 
Specifies the Firewall-and-NAT action to add/configure/delete. 
action_name
 must be the name of a Firewall-and-NAT action, and must be an alphanumeric string of 1 
through 63 characters. Each Firewall-and-NAT action must have a unique name. 
-noconfirm
 
Specifies that the command must execute without prompting for confirmation. 
Usage 
Use this command to create/configure/delete a Firewall-and-NAT action. 
On entering this command, the CLI prompt changes to: 
[context_name]hostname(config-fw-and-nat-action)#
 
Also see the Firewall-and-NAT Action Configuration Mode Commands chapter. 
Example
 
The following command creates a Firewall-and-NAT action named 
test1
, and changes to the Firewall-and-
NAT Action Configuration Mode: