Cisco Cisco ASR 5000
Global Configuration Mode Commands (L-S)
▀ sctp-param-template
▄ Command Line Interface Reference, StarOS Release 18
5534
sctp-param-template
This command allows you to create an SCTP parameter template and enter the SCTP Parameter Template Configuration
Mode. This mode is used to configure parameters for SCTP associations.
Mode. This mode is used to configure parameters for SCTP associations.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
[ no ] sctp-param-template name
no
Removes the specified SCTP parameter template from the system.
name
Specifies the name of the SCTP parameter template being created or accessed.
name
must be an
alphanumeric string of 1 through 63 characters.
Usage
Use this command to enter the SCTP Parameter Template Configuration mode.
Entering this command results in the following prompt:
Entering this command results in the following prompt:
[context_name]host(sctp-param-template)#
SCTP Parameter Template Configuration Mode commands are defined in the SCTP Parameter Template
Configuration Mode Commands chapter.
Configuration Mode Commands chapter.
Important:
The SCTP parameters will be activated in a service only if the corresponding
service restarts or if the SCTP parameter template is re-associated with its corresponding service.
The SCTP parameters will not be active if the SCTP template is changed.
The SCTP parameters will not be active if the SCTP template is changed.
Example
The following command creates a new SCTP parameter template or enters an existing template named
sctp-
tmpl2
:
sctp-param-template sctp-tmpl2