Cisco Cisco ASR 5000

Page of 9109
Global Configuration Mode Commands (T-threshold phspc)   
▀  threshold dns-lookup-failure 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
5672 
   
threshold dns-lookup-failure 
Configures alarm or alert thresholds based on the percentage of total DNS lookup failures. 
Product
 
ACS 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration 
configure
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config)# 
Syntax
 
threshold dns-lookup-failure 
default
 
Configures this command with the default threshold setting. 
Default: 90 percent. It is the same for both high and low thresholds. 
high_thresh
 
Default: 90 percent 
Specifies the high threshold for percentage of total DNS lookup failures. When the percentage of total 
failures meets or exceeds the high threshold at the end of the polling interval, an alert or alarm is generated. 
high_thresh
 is an integer value from 0 through 100. When configured to 0 the threshold is disabled. 
clear low_thresh
 
Default: 90 percent 
Specifies the low threshold for percentage of total DNS lookup failures. When the percentage of total failures 
goes below the low threshold within the polling interval, a clear alarm is generated. 
low_thresh
 is an integer value from 0 through 100. When configured to 0 the threshold is disabled. 
Important:
  This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm 
model, the system assumes it is identical to the low threshold. 
Usage 
Use this command to configure thresholds for the percentage of total DNS lookup failures. Note that this 
threshold applies to both IPv4 and IPv6 DNS entries. 
Alerts or alarms are triggered based on the following rules: 
 
Enter condition: Actual percentage of total DNS lookup failures is greater than or equal to the 
specified percentage of total DNS lookup failures.