Cisco Cisco ASR 5000

Page of 9109
Global Configuration Mode Commands (T-threshold phspc)   
▀  threshold per-service-gprs-pdp-sessions 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
5726 
   
threshold per-service-gprs-pdp-sessions 
Configures alarm or alert thresholds for the number of 2G-activated PDP contexts per GPRS service. 
Product
 
SGSN 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration 
configure
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config)# 
Syntax
 
threshold per-service-gprs-pdp-sessions high_thresh  [ clear low_thresh ] 
high_thresh
 
Default: 0 
Specifies the high threshold number of 2G-activated PDP contexts for any one GPRS service. This number 
must be met or exceeded within the polling interval to generate an alert or alarm. 
high_thresh
 is an integer from 0 through 4000000. A value of 0 disables the threshold. 
clear
 
low_thresh
 
Default: 0 
Specifies the low threshold number of 2G-activated PDP contexts for any one GPRS service. This number or 
higher maintains a previously generated alarm condition. If the number of sessions falls beneath the low 
threshold within the polling interval, then a clear alarm will be generated. 
low_thresh
 is an integer from 0 through 4000000. A value of 0 disables the threshold. 
Important:
  This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm 
model, the system assumes it is identical to the high threshold. 
Usage 
Monitor and set alarms or alerts when the number of 2G-activated PDP contexts for any GPRS service in the 
system is equal to or greater than the set limit. 
Alerts or alarms are triggered for PDP contexts based on the following rules: 
 
Enter condition: Actual number of PDP contexts for any GPRS service is greater than or equal to the 
high threshold. 
 
Clear condition: Actual number of PDP contexts is less than the low threshold. 
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end 
of the polling interval. 
Refer to the 
threshold poll
 command to configure the polling interval and the 
threshold monitoring
 
command to enable thresholding for this value.