Cisco Cisco ASR 5000

Page of 9109
Global Configuration Mode Commands (T-threshold phspc)   
▀  threshold per-service-samog-sessions 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
5736 
   
threshold per-service-samog-sessions 
Configures alarm or alert thresholds for the number of S2a Mobility over GTP (SaMOG) sessions per SaMOG service 
in the system. 
Product
 
SaMOG 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration 
configure
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config)# 
Syntax
 
threshold per-service-samog-sessions high_thresh  [ clear low_thresh ] 
high_thresh
 
Default: 0 
Specifies the high threshold number of SaMOG sessions for any one SaMOG service that must be met or 
exceeded within the polling interval to generate an alert or alarm. 
high_thresh
 is an integer from 0 through 4,000,000. A value of 0 disables the threshold. 
clear
 
low_thresh
 
Default: 0 
Specifies the low threshold number of SaMOG sessions for any one SaMOG service that maintains a 
previously generated alarm condition. If the number of SaMOG sessions falls beneath the low threshold 
within the polling interval, a clear alarm will be generated. 
low_thresh
 is an integer from 0 through 4,000,000. A value of 0 disables the threshold. 
Important:
  This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm 
model, the system assumes it is identical to the high threshold. 
Usage 
Monitor and set alarms or alerts when the number of SaMOG sessions for any SaMOG service in the system 
is equal to or greater than the set limit. 
Alerts or alarms are triggered for SaMOG sessions based on the following rules: 
 
Enter condition: Actual number of SaMOG sessions for any SaMOG service is greater than or equal to 
the high threshold. 
 
Clear condition: Actual number of SaMOG sessions is less than the low threshold. 
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end 
of the polling interval. 
Refer to the 
threshold poll
 command to configure the polling interval for this value.