Cisco Cisco ASR 5000

Page of 9109
Global Configuration Mode Commands (T-threshold phspc)   
▀  threshold phsgw-network-entry-denial 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
5754 
   
threshold phsgw-network-entry-denial 
Configures, alarm or alert thresholds for the number of network entry denials in PHSGW. 
Product
 
PHSGW 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration 
configure
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config)# 
Syntax
 
threshold phsgww-max-network-entry-denial high_thresh  [ clear low_thresh ] 
high_thresh
 
Default: 0 
Specifies the high threshold number of network entry denials for any one PHSGW service. This number must 
be met or exceeded within the polling interval to generate an alert or alarm. 
high_thresh
 is an integer from 0 through 1000000. A value of 0 disables the threshold. 
clear
 
low_thresh
 
Default: 0 
Specifies the low threshold number of network entry denials for any one PHSGW service. This number must 
be met or exceeded to maintain a previously generated alarm condition. If the number of subscribers falls 
beneath the low threshold within the polling interval, a clear alarm will be generated. 
low_thresh
 is an integer from 0 through 1000000. A value of 0 disables the threshold. 
Important:
  This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm 
model, the system assumes it is identical to the high threshold. 
Usage 
Set the monitoring and clearing thresholds for PHSGW network entry denials. 
Alerts or alarms are triggered for handoff denials based on the following rules: 
 
Enter condition: Actual number of PHSGW network entry denials in any one PHSGW service is 
greater than or equal to the high threshold. 
 
Clear condition: Actual number of PHSGW network entry denials in any one PHSGW service is less 
than the low threshold. 
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end 
of the polling interval. 
Refer to the 
threshold poll
 command to configure the polling interval and the 
threshold monitoring
 
command to enable thresholding for this value.