Cisco Cisco ASR 5000

Page of 9109
Global Configuration Mode Commands (threshold poll commands O - Z)   
▀  threshold poll phsgw-max-eap-retry interval 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
5892 
   
threshold poll phsgw-max-eap-retry interval 
Configures the polling interval in seconds over which to count the maximum number of Extensible Authentication 
Protocol (EAP) retries in PHSGW. 
Product
 
PHSGW 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration 
configure
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config)# 
Syntax
 
threshold poll phsgw-max-eap-retry interval duration 
interval duration
 
Default: 0 seconds. 
Specifies the amount of time (in seconds) that comprises the polling interval. 
duration
 must be an integer from 30 through 60000. 
Usage 
This command sets the time period over which to monitor the specified value for threshold crossing. 
Important:
  All configured polling intervals are rounded up to the closest multiple of 30. For example, if a 
polling interval is configured for 130 seconds, the system uses a polling interval of 150 seconds. 
Refer to the 
threshold monitoring
 and other threshold commands for additional information on the 
system’s support for thresholds in this chapter. 
Important:
  To enable an SNMP trap for monitoring this threshold use the 
snmp trap enable 
ThreshPHSGWMaxEAPRetry
 command in this mode. 
Example
 
The following command configures the polling interval to 
600
 seconds for PHSGW EAP retries: 
threshold poll phsgw-max-eap-retry interval 600