Cisco Cisco ASR 5000
GPRS Service Configuration Mode Commands
s4-overcharge-protection ▀
Command Line Interface Reference, StarOS Release 18 ▄
6061
s4-overcharge-protection
This command enables or disables Subscriber Overcharging Protection functionality for the S4-SGSN in the 2G
network and associates a BSSGP cause code group with the GPRS Service configuration.
network and associates a BSSGP cause code group with the GPRS Service configuration.
Important:
We recommend that you enable Release Access Bearer, with the
release-access-bearer
command
in the Call-Control Profile configuration mode, before this
s4-overcharge-protection
command is
used to enable Subscriber Overcharging Protection.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > GPRS Service Configuration
configure > context context_name > gprs-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-gprs-service)#
Syntax
s4-overcharge-protection bssgp-cause-code-group group_name
no s4-overcharge-protection
no
Disables Subscriber Overcharging Protection functionality for 2G. Disabled is the default.
bssgp-cause-code-group group_name
Associates a BSSGP cause code group with the GPRS Service configuration. You can enter a group’s name
before the cause code group is actually created but the names must match.
before the cause code group is actually created but the names must match.
group_name
: Enter an alphanumeric string up to 16 characters long to identify the cause code group.
Usage
The cause code group is created with the
cause-code-group
command in the LTE Policy configuration
mode.
To see the name of the defined cause code group(s) or the configuration of the BSSGP cause code groups, use
the
To see the name of the defined cause code group(s) or the configuration of the BSSGP cause code groups, use
the
show lte-policy cause-code-group [ name | summary ]
command in Exec mode.
To see the status of the Subscriber Overcharging Functionality and the associated BSSGP cause code group,
use Exec command
use Exec command
show gprs-service name
service_name
.
Important:
If Release Access Bearer is enabled and going out of the S4-SGSN, the ARRL bit will be included if
this CLI is enabled and if LORC (loss of radio coverage) is detected.