Cisco Cisco ASR 5000

Page of 9109
ACS Packet Filter Configuration Mode Commands   
▀  ip remote-port 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
628 
   
ip remote-port 
This command allows you to configure the IP remote port(s) for the current packet filter. 
Product
 
ACS 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > ACS Configuration > Packet Filter Configuration 
active-charging service service_name > packet-filter packet_filter_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-packet-filter)# 
Syntax
 
ip remote-port { = port_number | range start_port_number to end_port_number } 
no ip remote-port 
no
 
If previously configured, deletes the ip remote-port configuration from the current packet filter. 
port_number
 
Specifies the port number of the transport protocol. 
port_number
 must be the port number, and must be an integer from 1 through 65535. 
range start_port_number to end_port_number
 
Specifies a range of port numbers. 
start_port_number
 and 
end_port_number
 must be integers from 1 through 65535. 
end_port_number
 must be greater than 
start_port_number
Usage 
Use this command to configure the IP remote port(s) for a packet filter. 
Example
 
The following command configures the IP remote port as 
789
ip remote-port = 789