Cisco Cisco ASR 5000
HSGW Service Configuration Mode Commands
network-initiated-qos ▀
Command Line Interface Reference, StarOS Release 18 ▄
6367
network-initiated-qos
Enables the use of network initiated QoS functionality.
Product
HSGW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > HSGW Service Configuration
configure > context context_name > hsgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-hsgw-service)#
Syntax
[ default | no ] network-initiated-qos
default
Returns the command to its default setting of enabled.
no
Disables the ability to use network initiated QoS functionality.
Usage
Use this command to enable or disable support for network initiated QoS functionality. Network initiated
QoS is enabled by default.
When network initiated QoS functionality is enabled, if the vendor specific network control protocol
(VSNCP) protocol configuration options (PCO) arrive from the UE with the BCM set, the HSGW CCR-I
includes the Network-Request-Support AVP. If the PCRF behavior returns a BCM of MS+NW when this
AVP is received, then flows originating from the network (RSVP Resv) would be triggered upon a PCC-Rule
install.
QoS is enabled by default.
When network initiated QoS functionality is enabled, if the vendor specific network control protocol
(VSNCP) protocol configuration options (PCO) arrive from the UE with the BCM set, the HSGW CCR-I
includes the Network-Request-Support AVP. If the PCRF behavior returns a BCM of MS+NW when this
AVP is received, then flows originating from the network (RSVP Resv) would be triggered upon a PCC-Rule
install.