Cisco Cisco ASR 5000

Page of 9109
HNB-CS Network Configuration Mode Commands   
▀  map lac 
 
 
▄  Command Line Interface Reference, StarOS Release 18 
6412 
   
map lac 
Configures the mapping of the Location Area Code (LAC) received from UE to an MSC point code. This is an 
important configuration for CS network resource sharing without Iu-Flex interface configuration. 
Product
 
HNB-GW 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > HNB-CS Network Configuration 
configure > cs-network cs_instance
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-cs-network-instance_id)# 
Syntax
 
map lac range lac_start to lac_end point-code msc_point_code 
no map lac range lac_start to lac_end 
no
 
Removes the entries of mapping of range of LACs received from UE with particular MSC point code. 
range
 
lac_start
 
to
 
lac_end
 
Specifies the range of LACs received from UE to map with particular MSC point code during initial CS core 
network node selection. 
lac_start
 is an integer from 0 through 65535 that should be less than 
lac_end
lac_end
 is an integer from 0 through 65535 that should be more than 
lac_start
The command can be entered more than once to map multiple LAC ranges to same MSC, but overlapping is 
not allowed. 
point-code msc_point_code
 
Specifies the SS7 address of the MSC in the CS network to map with a range of LAC values. 
point_code
 is an SS7 point code in dotted-decimal ###.###.### or 8-digit decimal ######## format. 
Usage 
Use this command to map a LAC, received from UE during HNB registration, for MSC selection over IuCS 
interface through LAC range mapping with MSC point code. 
This configuration is used during initial CS core network node selection when the LAC from the UE is 
available. This configuration is used when the core network is not using Iu-Flex interface for MSC selection. 
The command can be entered more than once to map multiple LAC ranges to same MSC point code.