Cisco Cisco ASR 5000

Page of 9109
  LTE Policy Configuration Mode Commands 
sgsn-mme  ▀   
 
Command Line Interface Reference, StarOS Release 18  ▄  
 
   
7177 
sgsn-mme 
This command is used to enable or disable subscriber data optimization in a SGSN-MME combo node. 
Product
 
SGSN 
MME 
Privilege
 
Administrator 
Mode
 
Exec > Global Configuration > LTE Policy Configuration 
configure > lte-policy
 
Entering the above command sequence results in the following prompt: 
[local]host_name(lte-policy)# 
Syntax
 
[ no ] sgsn-mme subscriber-data-optimization 
no
 
Disables the configured optimization in a SGSN-MME combo node. 
subscriber-data-optimization
 
Enables subscriber data optimization in a SGSN-MME combo node. 
Usage 
This command is used to configure data optimization in a SGSN-MME combo node. When this command is 
configured in a co-located SGSN and MME node, lower memory or CPU utilization and reduced signaling 
towards other nodes in network is achieved. This feature is supported by both the S4-SGSN and the Gn-
SGSN. For the feature to apply to a Gn-SGSN, the Gn-SGSN must be configured to connect to an HSS. The 
is a licensed Cisco feature. A separate feature license is required. Contact your Cisco account representative 
for detailed information on specific licensing requirements. For information on installing and verifying 
licenses, refer to the Managing License Keys section of the Software Management Operations chapter in the 
System Administration Guide
 
Example
 
The following command is used to enable subscriber data optimization in a SGSN-MME combo node. 
sgsn-mme subscriber-data-optimization