Cisco Cisco ASR 5000
ACS Rulebase Configuration Mode Commands
nat policy ▀
Command Line Interface Reference, StarOS Release 18 ▄
747
Important:
Including the default NAT realm, a maximum of three NAT realms are supported.
Usage
Use this command to enable/disable NAT processing for all subscribers using the current rulebase.
After NAT is enabled for a subscriber, the NAT IP address to be used is chosen from the NAT realms defined
in the rule priority lines within the rulebase. See the
After NAT is enabled for a subscriber, the NAT IP address to be used is chosen from the NAT realms defined
in the rule priority lines within the rulebase. See the
NAT enable/disable status in the rulebase can be changed any time, however the changed NAT status will not
be applied for active calls using the rulebase. The new NAT status is only applied to new calls.
be applied for active calls using the rulebase. The new NAT status is only applied to new calls.
Example
The following command enables NAT processing:
nat policy nat-required
The following command disables NAT processing:
no nat policy