Cisco Cisco ASR 5000
ACS Rulebase Configuration Mode Commands
post-processing priority ▀
Command Line Interface Reference, StarOS Release 18 ▄
757
post-processing priority
This command allows you to configure the post-processing priority and action to be taken on specific ruledef in the
current rulebase.
current rulebase.
Important:
This command is only available in StarOS 8.3 and later releases.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
post-processing priority priority { group-of-ruledefs ruledefs_group_name | ruledef
ruledef_name } charging-action charging_action_name [ description description ]
ruledef_name } charging-action charging_action_name [ description description ]
no post-processing priority priority
no
If previously configured, deletes the specified post-processing priority configuration from the current
rulebase.
rulebase.
priority priority
Specifies priority for the ruledef/group-of-ruledefs in the current rulebase.
priority
must be a unique value in the current rulebase, and must be an integer from 1 through 65535.
group-of-ruledefs ruledefs_group_name
Specifies the group-of-ruledefs.
ruledefs_group_name
must be the name of a group-of-ruledefs, and must be an alphanumeric string of 1
through 63 characters.
Important:
The group-of-ruledefs specified must be configured for post-processing. See the
group-of-
ruledefs-application
command in the ACS Group-of-Ruledefs Configuration mode.
ruledef ruledef_name
Specifies the ruledef.
ruledef_name
must be the name of a ruledef, and must be an alphanumeric string of 1 through 63
characters.