Cisco Cisco ASR 5000
ACS Rulebase Configuration Mode Commands
▀ tethering-detection
▄ Command Line Interface Reference, StarOS Release 18
782
Usage
Use this command to enable/disable the Tethering Detection feature for a rulebase, and configures the
database to use. Tethering Detection can be done for IPv4, IPv6, TCP and UDP flows.
Changing the configuration does not affect existing flows of the subscriber. If Tethering Detection was
disabled and is turned enabled, it will be applied only to new flows of subscribers using the rulebase.
database to use. Tethering Detection can be done for IPv4, IPv6, TCP and UDP flows.
Changing the configuration does not affect existing flows of the subscriber. If Tethering Detection was
disabled and is turned enabled, it will be applied only to new flows of subscribers using the rulebase.
Important:
IPv6 Tethering Detection is supported only with TTL and UA signatures, and not supported for OS
signatures.
Also, see the
tethering-database
command in the ACS Configuration Mode Commands chapter.
Example
The following command enables the Tethering Detection feature in the rulebase, and specifies to use only the
OS database:
OS database:
tethering-detection os-db-only