Cisco Cisco ASR 5000
ACS Ruledef Configuration Mode Commands
if-protocol ▀
Command Line Interface Reference, StarOS Release 18 ▄
931
if-protocol
This command allows you to associate different content IDs with the same ruledef, depending on the protocol being
used.
used.
Important:
In StarOS 18.0 and later releases, this command has been deprecated.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
if-protocol { http | wsp-connection-less | wsp-connection-oriented } content-id
content_id
content_id
no if-protocol { http | wsp-connection-less | wsp-connection-oriented }
no
If previously configured, deletes the specified rule expression from the current ruledef.
http
Specifies HTTP protocol.
This is the same as the rule expression
This is the same as the rule expression
http any-match = true
.
wsp-connection-less
Specifies WSP connection-less protocol.
This is the same as requiring “
This is the same as requiring “
wsp any-match = true
” but “
wtp any-match = false
” (that is,
connection-less WAP1.x).
wsp-connection-oriented
Specifies WSP connection-oriented protocol.
This is the same as the combined rule expression “
This is the same as the combined rule expression “
wsp any-match = true
” and “
wtp any-match =
true
” (that is, connection-oriented WAP1.x).
content-id content_id
Specifies the content ID for the specified protocol.
In 12.1 and earlier releases,
In 12.1 and earlier releases,
content_id
must be an integer from 1 through 65535.
In 12.2 and later releases,
content_id
must be an integer from 1 through 2147483647.