Cisco Cisco Packet Data Gateway (PDG)
S-GW Service Configuration Mode Commands
▀ ddn throttle
▄ Command Line Interface Reference, StarOS Release 18
8724
can dynamically request S-GW to reduce a certain percentage of DDN messages sent towards it for a given
period time.
The S-GW supports the following IEs for this feature:
period time.
The S-GW supports the following IEs for this feature:
ARP IE in Downlink Data Notification
DL Low Priority Traffic Throttling IE in DDN Acknowledge Message
More information is available in Release 10 of 3GPP 29.274, section 5.3.4.3.
The S-GW supports DDN throttling for up to 24 MMEs. DDNs for additional MMEs (25+) will be sent as
normal and will not be throttled.
Throttling statistics can be viewed by issuing the Exec mode command:
The S-GW supports DDN throttling for up to 24 MMEs. DDNs for additional MMEs (25+) will be sent as
normal and will not be throttled.
Throttling statistics can be viewed by issuing the Exec mode command:
show sgw-service statistics all
Example
The following command sets the ARP watermark lowest priority to
10
seconds:
ddn throttle arp-watermark 10
If the ARP value provided is 10, all bearers with ARP value between 10-15 are treated as low priority bearers
and are given throttling treatment. Throttling would not be enabled if the ARP value is not provided through
S-GW service configuration. Also, the ARP IE in DDN message towards MME would not be included unless
DDN throttling is configured in S-GW service.
and are given throttling treatment. Throttling would not be enabled if the ARP value is not provided through
S-GW service configuration. Also, the ARP IE in DDN message towards MME would not be included unless
DDN throttling is configured in S-GW service.