Cisco Cisco ASR 5700

Page of 8994
ACS Ruledef Configuration Mode Commands   
▀  rule-application 
 
 
▄  Command Line Interface Reference, StarOS Release 17 
1088 
   
rule-application 
This command allows you to specify the purpose of a ruledef, such as for charging, post-processing, routing, and so on. 
Product
 
ACS 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > ACS Configuration > Ruledef Configuration 
active-charging service service_name > ruledef ruledef_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-acs-ruledef)# 
Syntax
 
rule-application { charging | post-processing | routing | tpo } 
no rule-application 
no
 
Disables the rule application configuration. 
charging
 
Specifies that the current ruledef is for charging purposes. 
Up to 2,048 rule definitions can be defined for the charging application in an Active Charging Service. 
Default: Enabled 
post-processing
 
Important:
  The 
post-processing
 keyword is available only in 8.3 and later releases. 
Specifies that the current ruledef is for post-processing purposes. This enables processing of packets even if 
the rule matching for them has been disabled. 
routing
 
Specifies that the current ruledef is for routing purposes. Up to 256 rule definitions can be defined for routing 
in an Active Charging Service. Default: Disabled 
tpo
 
Important:
  The Traffic Performance Optimization (TPO) in-line service is not supported in this release.