Cisco Cisco ASR 5700
APN Configuration Mode Commands
▀ egtpc-qci-stats
▄ Command Line Interface Reference, StarOS Release 17
1336
qci5
Configure apn-qci-egtpc statistics for QCI 5.
qci6
Configure apn-qci-egtpc statistics for QCI 6.
qci7
Configure apn-qci-egtpc statistics for QCI 7.
qci8
Configure apn-qci-egtpc statistics for QCI 8.
qci9
Configure apn-qci-egtpc statistics for QCI 9.
+
More than one of the above keywords can be entered within a single command.
Usage
Use this command to enable/disable an APN candidate list for the APN Expansion bulkstats schema. You can
enable which APN collects granular statistics using this configuration. In those granular statistics, it is
possible to decide which particular statistics to collect.
enable which APN collects granular statistics using this configuration. In those granular statistics, it is
possible to decide which particular statistics to collect.
Caution:
Supporting more granular statistics/bulkstats on APN (up to 2,000 APNs are supported) has an impact
on system performance. Statistics need to be obtained at regular intervals for a few minutes. Each of these retrievals can
lead to gigabytes of information being gathered and consolidated. Due to this issue, granular bulkstats collection is
restricted/controlled.
lead to gigabytes of information being gathered and consolidated. Due to this issue, granular bulkstats collection is
restricted/controlled.
See the APN Expansion Schema Statistics chapter in the Statistics and Counters Reference for detailed
information on these bulkstats.
information on these bulkstats.
Example
The following command configures all QCI bulkstats in the apn-expansion schema.
egtpc-qci-stats all