Cisco Cisco ASR 5700

Page of 8994
APN Profile Configuration Mode   
▀  qos pgw-upgrade 
 
 
▄  Command Line Interface Reference, StarOS Release 17 
1538 
   
qos pgw-upgrade 
Configures the action to be taken when the MME receives a QoS upgrade from P-GW for default bearers/Non-
Guaranteed Bit Rate (Non-GBR) bearers. 
Product
 
MME 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > APN Profile Configuration 
configure > apn-profile profile_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(apn-profile-profile_name)# 
Syntax
 
qos pgw-upgrade non-gbr { accept | reject | locally-cap }  
[ remove ] qos pgw-upgrade non-gbr 
remove
 
Removes the configuration, returning the system to the default setting where the MME accepts the P-GW 
upgraded QoS values for Non-GBR (default) bearers. 
non-gbr { accept | reject | locally-cap }
 
For Non-GBR (default) bearers, this keyword configures the action the MME takes when it receives a P-GW 
upgraded QoS value. 
 
accept
: The MME will accept the P-GW upgraded QoS values. 
 
reject
: The MME will reject the P-GW upgraded QoS values. 
 
locally-cap
: The MME compares QCI, ARP and ARP-PVI provided by P-GW to the locally 
configured values of those parameters. If the values match, then accepts towards the P-GW and use 
locally configured values towards the UE/RAN for APN-AMBR and ARP-PCI. If the values do not 
match, the MME rejects the P-GW upgraded QoS values.  
Usage 
Use this command to provide configurability at the APN Profile level for the MME to accept, reject, or 
locally-cap P-GW upgraded QoS values for default (non-GBR) bearers. This S11 Control is applied 
whenever QoS parameters are received on S11 interface. The relevant procedures for default bearers are 
Create Session Response (sent by P-GW during Attach, UE requested PDN connectivity) and Update Bearer 
Procedures (initiated by P-GW resulting from trigger QoS change or other in PCEF/PCRF, or from Modify 
Bearer Command or Bearer Resource Command sent by MME). Note: This configuration is supported only 
for Default bearers (i.e Non-GBR bearers) in a roaming scenario. 
The MME will set the sum of the APN-AMBR of all active APNs up to the value of the subscribed UE-
AMBR, subject to the UE-AMBR restriction.