Cisco Cisco ASR 5700

Page of 8994
Call Control Profile Configuration Mode   
▀  attach imei-query-type 
 
 
▄  Command Line Interface Reference, StarOS Release 17 
1906 
   
attach imei-query-type 
Defines device Attach limitations for this call control profile if an IMEI is not already present in the Attach Request. 
Product
 
MME 
SGSN 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > Call Control Profile Configuration 
configure > call-control-profile profile_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-call-control-profile-profile_name)# 
Syntax
 
attach imei-query-type { imei | imei-sv | none } [ verify-equipment-identity [ allow-on-
eca-timeout | deny-greylisted | deny-unknown | verify-emergency ] + ]
 
remove attach imei-query-type 
remove
 
Deletes the specified attach configuration. 
imei-query-type { imei | imei-sv | none }
 
Configures system behavior during Attach procedures if an IMEI is not already present in the Attach Request. 
 
imei
: Specifies that the system is required to query the UE for its International Mobile Equipment 
Identity (IMEI). 
 
imei-sv
: Specifies that the system is required to query the UE for its International Mobile Equipment 
Identity - Software Version (IMEI-SV). 
 
none
: Specifies that the system does not need to query for IMEI or IMEI-SV. 
verify-equipment-identity [ allow-on-eca-timeout | deny-greylisted | deny-unknown 
| verify-emergency ]
 
Specifies that the identification (IMEI or IMEI-SV) of the UE is to be performed by the Equipment Identity 
Register (EIR) over the S13 interface. 
 
allow-on-eca-timeout
: Configures the MME to allow equipment that has timed-out on ECA during 
the attach procedure. 
 
deny-greylisted
: Configures the MME to deny grey-listed equipment during the attach procedure. 
 
deny-unknown
: Configures the MME to deny unknown equipment during the attach procedure. 
 
verify-emergency
: Configures the MME to ignore the IMEI validation of the equipment during the 
attach procedure in emergency cases. This keyword is only supported in release 12.2 and higher.