Cisco Cisco ASR 5700

Page of 8994
  Call Control Profile Configuration Mode 
local-cause-code-mapping pgw-selection-failure  ▀   
 
Command Line Interface Reference, StarOS Release 17  ▄  
 
   
1999 
local-cause-code-mapping pgw-selection-failure 
Configures the reject cause code to send to a UE when a failure occurs during P-GW selection. 
Product
 
MME 
Privilege
 
Administrator 
Mode
 
Exec > Global Configuration > Call Control Profile Configuration 
configure > call-control-profile profile_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-call-control-profile-profile_name)# 
Syntax
 
local-cause-code-mapping pgw-selection-failure emm-cause-code { eps-service-not-allowed-
in-this-plmn | network-failure | no-suitable-cell-in-tracking-area | plmn-not-allowed | 
roaming-not-allowed-in-this-tracking-area | tracking-area-not-allowed } 
 
remove local-cause-code-mapping pgw-selection-failure  
remove local-cause-code-mapping pgw-selection-failure
 
Removes the configured cause code mapping. 
pgw-selection-failure emm-cause-code { eps-service-not-allowed-in-this-plmn | 
network-failure | no-suitable-cell-in-tracking-area | plmn-not-allowed | roaming-
not-allowed-in-this-tracking-area | tracking-area-not-allowed }
 
Specifies the EPS Mobility Management (EMM) cause code to return when a failure occurs during P-GW 
selection. 
 
eps-service-not-allowed-in-this-plmn
 
 
network-failure
 
 
no-suitable-cell-in-tracking-area
 
 
plmn-not-allowed
 
 
roaming-not-allowed-in-this-tracking-area
 
 
tracking-area-not-allowed
 
Usage 
Use this command to configure the cause code returned to a UE when a failure occurs during P-GW 
selection. By default, the MME sends the UE the #17 - Network failure cause code when encountering this 
condition.