Cisco Cisco ASR 5700

Page of 8994
  Card Configuration Mode Commands 
framing  ▀   
 
Command Line Interface Reference, StarOS Release 17  ▄  
 
   
2143 
sonet [ ds1 | e1 ]
 
Configures the system to use SONET signal framing for either an OLC/OLC2 or CLC/CLC2 line card in an 
SGSN. 
Default: SONET is the default framing type for an OLC/OLC2 or CLC/CLC2 line card. 
Important:
  Using this keyword with an Ethernet line card takes the line card offline. 
In releases 8.1 and higher, you can also set the type of signaling path for a CLC2. 
ds1
 - configures the card to support a DS1/T. This is the default for SONET. 
e1
 - configures the card to support an E1. 
unspecified
 
Configures the system to use the default framing type for the particular line card resident in the identified 
slot. 
-noconfirm
 
Instructs the system to execute the command without additional prompting for command confirmation. 
Usage 
Use the 
framing
 command to identify the type of signal framing to be used by the line card in the identified 
slot. 
Note that each type of line card uses a different type of signal framing. If you configure the wrong framing 
type for a line card, the line card is taken offline. 
Important:
  This command is not supported on all platforms. 
Example
 
Use the following command to configure SDH signal framing on a CLC2. If you do not include the path-type, 
the default of 
e1
 is automatically included in the card’s framing configuration: 
framing sdh