Cisco Cisco ASR 5700

Page of 8994
AAL2 Node Configuration Mode Commands   
▀  aal2-path-id 
 
 
▄  Command Line Interface Reference, StarOS Release 17 
220 
   
aal2-path-id 
This command set the AAL2 path identifier with AAL2 node and also used to block a particular AAL2 path. 
Product
 
HNB-GW 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > Context Configuration > ALCAP Service Configuration > AAL2 Node Configuration 
configure > context context_name > alcap-service service_name > aal2-node node_name
 
Entering the above command sequence results in the following prompt: 
[context_name]host_name(config-aal2-node-node_name)# 
Syntax
 
[no] aal2-path-id aal2_path_id [block] 
no
 
Removes the configured AAL2 path identifier from this AAL2 node configuration. 
aal2_path_id
 
Specifies the AAL2 path identifier configured with adjacent AAL2 node(s). The AAL2 path id must be 
unique within an AAL2 node configuration. This value is used to identify a particular path towards an 
adjacent AAL2 node and is sent in ALCAP protocol messages to peer where path identification is required. 
The 
aal2_path_id
 must be an integer between 1 through 4294967295. 
Important:
  This AAL2 path id 
aal2_path_id
 will be used to bind with ATM port in PVC configuration mode 
of ATM configuration mode. 
block
 
This keyword block the AAL2 path configured with specific path identifier. When this keyword is executed 
ALCAP-BLO-REQUEST shall be sent to the adjacent AAL2 node. 
To unblock an AAL2 path, the no keyword will be used for a locally blocked path by sending ALCAP-
UNBLOCK-REQUEST to the adjacent AAL2 node. 
Usage 
Use this command to configure an AAL2 path between a pair of adjacent nodes, which is identified by a 
unique number called AAL2 path identifier. An AAL2 path provides 248 AAL2 channels wherein each 
AAL2 channel is used for one circuit switched call. The AAL2 channel range defined is 8 to 255. 
This command can be used for blocking or unblocking an AAL2 path towards an adjacent AAL2 node. 
Important:
  The AAL2 path id configured here will be used to bind with ATM port in PVC configuration sub-
mode of ATM configuration mode for IuCS-over-ATM functionality.