Cisco Cisco ASR 5700
Congestion Action Profile Configuration Mode Commands
report-overload ▀
Command Line Interface Reference, StarOS Release 17 ▄
2245
enobeb-percentage percentage
Configures the percentage of known eNodeBs that will receive the overload report.
percentage
must be an integer from 1 through 100.
Usage
Configures the MME to invoke the S1 overload procedure (using the S1AP OVERLOAD START message)
to report overload conditions to the specified proportion of eNodeBs to which this MME has an S1 interface
connection. The MME selects the eNodeBs at random, such that two overloaded MMEs in the same pool do
not send overload messages to the same eNodeBs. When the MME has recovered and can increase its load,
the it sends an OVERLOAD STOP message to the eNodeBs.
to report overload conditions to the specified proportion of eNodeBs to which this MME has an S1 interface
connection. The MME selects the eNodeBs at random, such that two overloaded MMEs in the same pool do
not send overload messages to the same eNodeBs. When the MME has recovered and can increase its load,
the it sends an OVERLOAD STOP message to the eNodeBs.
Important:
The ‘report-overload’ option must be configured before the threshold is exceeded in order for the
action to take place.
Example
The following command configures the MME to report an overload condition to 50% of all known eNodeBs
and to request the eNodeBs to reject all non-emergency sessions to this MME until the overload condition is
cleared:
and to request the eNodeBs to reject all non-emergency sessions to this MME until the overload condition is
cleared:
report-overload reject-non-emergency-sessions enodeb-percentage 50