Cisco Cisco ASR 5700
Context Configuration Mode Commands A-D
▀ crypto group
▄ Command Line Interface Reference, StarOS Release 17
2338
crypto group
Creates or deletes a crypto group and enters the Crypto Configuration Mode allowing the configuration of crypto group
parameters.
parameters.
Product
HA
GGSN
PDIF
PDSN
Privilege
Administrator, Config-Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
[ no ] crypto group group_name
no
Deletes a previously configured crypto group.
group_name
Specifies the name of the crypto group as an alphanumeric string of 1 through 127 characters that is case
sensitive.
sensitive.
Important:
A maximum of 32 crypto groups per context can be configured.
Usage
Use this command to enter the configuration mode allowing the configuration of crypto group parameters.
Crypto (tunnel) groups are used to support the Redundant IPSec Tunnel Fail-over feature and consist of two
configured ISAKMP crypto maps. Each crypto map defines the IPSec policy for a tunnel. In the crypto group,
one tunnel serves as the primary, the other as the secondary (redundant).
Crypto (tunnel) groups are used to support the Redundant IPSec Tunnel Fail-over feature and consist of two
configured ISAKMP crypto maps. Each crypto map defines the IPSec policy for a tunnel. In the crypto group,
one tunnel serves as the primary, the other as the secondary (redundant).
Example
The following command configures a crypto group called
group1
:
crypto group group1