Cisco Cisco ASR 5700

Page of 8994
  ACL Configuration Mode Commands 
redirect css service (for uplink, by TCP/UDP packets)  ▀   
 
Command Line Interface Reference, StarOS Release 17  ▄  
 
   
353 
before
 
Indicates all rule definitions subsequent to this command are to be inserted before the command identified by 
the exact options listed. 
This moves the insertion point to be immediately before the rule definition which matches the exact options 
specified such that new rule definitions will be added, in order, before the matching rule definition. 
no
 
Removes the rule definition which exactly matches the options specified. 
css service service_name
 
The name of the active charging service to which packets are to be redirected. At the executive mode prompt, 
use the 
show active-charging service all
 command to display the names of all configured charging 
services. 
service_name
 must be an alphanumeric string from 1 through 15 characters. 
uplink
 
Apply this rule definition only to packets in the uplink (to the Mobile Node) direction. 
log
 
Default: packets are not logged. 
Indicates all packets which match the redirect are to be logged. 
tcp | udp
 
Specifies the redirect is to be applied to IP based transmission control protocol or the user datagram protocol. 
 
tcp
: Redirect applies to TPC packets. 
 
udp
: Redirect applies to UDP packets. 
source_address
 
The IP address(es) from which the packet originated. 
This option is used to filter all packets from a specific IP address or a group of IP addresses. 
When specifying a group of addresses, the initial address is configured using this option. The range can then 
be configured using the 
source_wildcard
 parameter. 
source_wildcard
 
This option is used in conjunction with the 
source_address
 option to specify a group of addresses for 
which packets are to be filtered. 
The mask must be entered as a complement: 
 
Zero-bits in this parameter mean that the corresponding bits configured for the 
source_address
 
parameter must be identical. 
 
One-bits in this parameter mean that the corresponding bits configured for the 
source_address
 
parameter must be ignored. 
any
 
Specifies that the rule definition applies to all packets.