Cisco Cisco ASR 5700

Page of 8994
  ACS Configuration Mode Commands 
idle-timeout  ▀   
 
Command Line Interface Reference, StarOS Release 17  ▄  
 
   
507 
idle-timeout 
This command allows you to configure the maximum duration a flow can remain idle for, after which the system 
automatically terminates the flow. 
Product
 
ACS 
NAT 
PSF 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > ACS Configuration 
active-charging service service_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-acs)# 
Syntax
 
idle-timeout { alg-media | flow-mapping { tcp | udp } | icmp | tcp [ half-open ] | udp } 
idle_timeout 
{ default | no } idle-timeout { alg-media | flow-mapping { tcp | udp } | icmp | tcp [ 
half-open ] | udp } 
 
default
 
Configures this command with the default setting for the specified parameter. 
Default:  
 
alg-media
: 120 seconds 
 
flow-mapping { tcp | udp }
: 300 seconds for TCP and 0 seconds for UDP 
 
icmp
tcp
udp
: 300 seconds 
 
tcp half-open
: 200 seconds 
no
 
Disables the idle-timeout configuration for the specified flow. 
alg-media
 
Configures the ALG media for the specified flow. 
flow-mapping { tcp | udp }
 
The Flow Mapping timer is an extension to the existing flow idle-timeout in ACS. This flow mapping timeout 
applies only for NAT enabled calls and is supported only for TCP and UDP flows. The purpose of this timer 
is to hold the resources (NAT IP, NAT port, Private IP NPU flow) associated with a 5-tuple flow until 
Mapping timeout expiry.