Cisco Cisco ASR 5700
ACS Configuration Mode Commands
rulebase-list ▀
Command Line Interface Reference, StarOS Release 17 ▄
569
rulebase-list
This command allows you to create and delete ACS rulebase lists.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration
active-charging service service_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs)#
Syntax
rulebase-list rulebase_list_name rulebase_name [ rulebase_name + ]
no rulebase-list rulebase_list_name
no
If previously configured, deletes the specified rulebase list from the active charging service.
rulebase_list_name
Specifies the rulebase list to add/modify/delete.
rulebase_list_name
must be the name of an ACS rulebase list, and must be an alphanumeric string of 1
through 63 characters.
rulebase_name
Specifies the rulebase name(s) to add to the rulebase list.
Each rulebase list must contain a minimum of one rulebase name, and the cumulative length of all rulebase
names must not exceed 256 bytes.
Each rulebase list must contain a minimum of one rulebase name, and the cumulative length of all rulebase
names must not exceed 256 bytes.
rulebase_name
must be the name of an ACS rulebase, and each rulebase name must be an alphanumeric
string of 1 through 63 characters.
Usage
Use this command to create or delete an ACS rulebase list. A rulebase list is a space-separated string of
rulebase names supplied to the OCS, from which the OCS chooses the rulebase to use for the subscriber. The
rulebase list to use for a subscriber is specified in the APN for the subscriber.
In 12.3 and earlier releases, a maximum of 20 rulebase lists can be configured.
In 14.0 and later releases, a maximum of 128 rulebase lists can be configured.
See the
rulebase names supplied to the OCS, from which the OCS chooses the rulebase to use for the subscriber. The
rulebase list to use for a subscriber is specified in the APN for the subscriber.
In 12.3 and earlier releases, a maximum of 20 rulebase lists can be configured.
In 14.0 and later releases, a maximum of 128 rulebase lists can be configured.
See the
active-charging rulebase-list
command in the APN Configuration Mode Commands
chapter.
Example
The following command creates a rulebase list named
rblist
, and adds the rulebases named
rulebase1
,
rulebase3
, and
rulebase5
to it: