Cisco Cisco ASR 5700

Page of 8994
  ACS Configuration Mode Commands 
ruledef  ▀   
 
Command Line Interface Reference, StarOS Release 17  ▄  
 
   
571 
ruledef 
This command allows you to create/configure/delete ACS rule definitions. 
Important:
  A maximum of 2048 ruledefs can be configured in the active charging service. 
Product
 
ACS 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > ACS Configuration 
active-charging service service_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-acs)# 
Syntax
 
ruledef ruledef_name [ -noconfirm ] 
no ruledef ruledef_name 
no
 
If previously configured, deletes the specified ruledef from the active charging service. 
ruledef_name
 
Specifies the ruledef to add/configure/delete. 
ruledef_name
 must be the name of an ACS ruledef, and must be an alphanumeric string of 1 through 63 
characters, and can contain punctuation characters. Each ruledef must have a unique name. Host pool, port 
map, IMSI pool, and firewall, routing, and charging ruledefs must have unique names. 
If the named ruledef does not exist, it is created, and the CLI mode changes to the ACS Ruledef 
Configuration Mode wherein the ruledef can be configured. 
If the named ruledef already exists, the CLI mode changes to the ACS Ruledef Configuration Mode for that 
ruledef. 
Important:
  If there are any changes to ruledef and the Override Control/Inheritance feature is enabled, then 
execute the CLI command “update active-charging override-control rulebase-config”. For more information on this 
command, see the Command Line Interface Reference
-noconfirm
 
Specifies that the command must execute without prompting for confirmation. 
Usage 
Use this command to create/configure/delete an ACS ruledef.