Cisco Cisco ASR 5700

Page of 8994
  ACS Readdress Server List Configuration Mode 
reactivation-time  ▀   
 
Command Line Interface Reference, StarOS Release 17  ▄  
 
   
637 
reactivation-time 
This command allows you to configure the time duration (in seconds) after which the status of a previously inactive 
server is rechecked. 
Important:
  This command is license dependent. For more information contact your Cisco account representative. 
Product
 
ACS 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > ACS Configuration > Readdress Server List Configuration 
active-charging service service_name > readdress-server-list server_list_name
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-readdress-server-list)# 
Syntax
 
reactivation-time reactivation_time 
default reactivation-time 
default
 
Configures this command with its default setting. 
Default: 300 seconds 
reactivation_time
 
Specifies the time duration after which the status of the inactive server is rechecked. 
reactivation_time
 must be an integer from 1 through 1800. 
Important:
  If not explicitly configured, the default value of 300 seconds will be used. 
Usage 
Use this command to configure the time duration (in seconds) after which the status of a previously inactive 
server is rechecked. 
Example
 
The following command configures the reactivation time to 
180
 seconds: 
reactivation-time 180